I just rebootet again from a bluescreen. What I did was:
I edited a material graph and used three “add” nodes to add up 4 scalar values. created a “clamp” node and connected it to the last sum node. When I pulled a wire out of the clamp result pin, I came about 30 pixels far, then bluescreen
Its not the first one and thats how it typically goes. They come literally out of the blue.
I have attached the content from the “[Project Name]/Saved/Logs” folder.
However, its only one file. I hope you can help me find out what is going on.
Your logs show that the bluescreen was not caused by the engine but but a crash in another section of windows. If I were to guess it would be an issue with your video card or windows managment. You can open Windows Event Viewer and look for the most critical error that happened around the time of your bluescreen and it should tell you exactly what DLL module failed. Feel free to pull the log (save Events from Event Viewer) and post a zipped copy of here and I will try to help you further.
