[BUG] Spline Mesh Component

Hi Epic,

Long time no see. – I’m currently experiencing an issue with meshes not displaying at 90 degrees if the Tagent’s of the previous, and next are the same.

I would show an image, but I can’t. So I hope this translate well. Basically when spline segment’s direction is 90 degrees, the tangent is given that same direction. This results in the Spline Mesh not being drawn, only until either one of the tangents are off not exactly the same. This has been my work around, but this may not always work and it will be distributed. So I would like to actually understand what the issue is to prevent it.

What is happening?

Thanks,
Peter