Alt key + Rotate doesn't rotate past 5 degrees

Community Community & Industry Discussion
, , ,
1

When holding alt and rotating the angle (to clone and angle any mesh) I get about 5 degrees of angle then the cloned object stops rotating, although I can see the gizmo rotate. I have a workaround, but thought I would point it out :slight_smile:

2

Hi ,

Unfortunately I have not been able to reproduce this effect, can you provide some reproduction steps so that I may follow along and re-create what you are describing? Thank you!

3

I noticed this happens also when you are cloning a actor in a collapsed folder (scene outliner). I am able to move it acouple units and then it stops moving and deselects itself. If you expand the folder it is in, it copies fine.

To reproduce:

  1. Create an actor.
  2. Put new actor in a folder in scene outliner.
  3. Collapse folder.
  4. Select actor, hold alt and move object.
4

Thanks canl, that was the very thing. :slight_smile:

Problem solved

5

By expanding the folder in the outliner I was able to achieve what I was after.

6

Hi everyone,

I was able to reproduce this effect when I followed the steps canl provided. I am attaching this and my findings to a bug report to be assessed. Thank you!