BP wire not staying connected

Botanicvelious · January 20, 2017, 6:05am

I have a bp service that is as follows,

when i compile the bp it works in the editor, however when i save and reload the editor the bp wire comes disconnected as shown

http://puu.sh/tsByw/ae5c61436d.png

After some additional troubleshooting I have found that it only happens to the service when its assigned to the behavior tree shown below.

http://puu.sh/tvxJk/df47154a74.png

Also tested with 4.15 P2 and same problem…

Botanicvelious · January 26, 2017, 2:09am

Setting the value to a variable didnt do anything however I found that if I make the value “Transient” in the ABaseUnit BP then the wires worked, in case anyone else runs into something like this in the future…

S-ed · January 26, 2017, 12:05am

Just my assumption but…try to set value to a variable.

It’s reoccurring bug since v4.7 or maybe even earlier. Happens when public variables are undefined.