Bug w/ hover mouse cursor in blueprints

Not sure how this made it through QA, perhaps it was intentional, but I prefer the old way!

Reproduce: Hover mouse over a pin with an attached wire in any blue print. Press Control key.

Results: Mouse cursor doesn’t change. Press Control key and it still doesn’t change.

Expected results: In V4.14.3 if you hover over a pin, the cursor would change to a crosshair. If you pressed Control, it turned into a little hand to let you know you would grab and drag the wire(s) to move them.

Hello Furroy,

Thank you for submitting a bug report. I have reproduced this issue and logged a report for it here

You can track the report’s status as the issue is reviewed by our development staff. Please be aware that this issue may not be prioritized or fixed soon.